14.1421 is the example result. Read it using the units and relationship stated below.
Wire Length uses start x, start y, end x.
Distinguishing electrical arithmetic from equipment selection
For wire length, the relationship is Result = √(([End X] − [Start X])^(2) + ([End Y] − [Start Y])^(2)). The amount depends on the supplied start x, start y, rather than a live market price or a value imported from another record. Power, energy, voltage and current describe different quantities. Watts represent a rate; watt-hours represent energy over time. Battery and inverter losses can reduce usable runtime even when the rated capacity is unchanged.
What the model includes
Result = √(([End X] − [Start X])^(2) + ([End Y] − [Start Y])^(2)) Read unit labels before comparing results. Motor estimates depend on phase, efficiency and power factor; energy budgets depend on duration and duty cycle. Nameplate values and measured consumption may differ under real loads. Treat the output as the stated estimate. It does not select a code-compliant conductor, protective device or complete installation. Equipment specifications and applicable requirements remain part of the design decision.
Example with the supplied inputs
Start X: 0; Start Y: 0; End X: 10; End Y: 10. Result: 14.1421. The values are illustrative.
Compare one changed input
End X changes from 10 to 11. The result becomes 14.8661. All other inputs remain fixed.
Calculation rule
Result = √(([End X] − [Start X])^(2) + ([End Y] − [Start Y])^(2))
Inputs and output
| Input | Example value | Entry convention |
|---|---|---|
| Start X | 0 | Use the source quantity represented by start x. Keep the counted population fixed and avoid mixing a unit value with a period total. |
| Start Y | 0 | Use the source quantity represented by start y. Keep the counted population fixed and avoid mixing a unit value with a period total. |
| End X | 10 | Use the source quantity represented by end x. Keep the counted population fixed and avoid mixing a unit value with a period total. |
| End Y | 10 | Use the source quantity represented by end y. Keep the counted population fixed and avoid mixing a unit value with a period total. |
Output: 14.1421 is the example result. Read it using the units and relationship stated below. Use the formula to distinguish a cash amount, count, percentage or ratio.
How to use the page
Collect the inputs
Gather Start X, Start Y, End X. Use one period and the units shown in the form.
Run the calculation
Enter the values and select the action. The calculation rule above explains how the inputs produce the result.
Compare a scenario
Change End X on its own, keeping the other inputs fixed. Read both results before changing another assumption.
Worked example
With the example inputs listed above, the result is 14.1421.
Change End X from 10 to 11 while keeping every other value fixed. The result becomes 14.8661. This comparison isolates that input; it does not forecast how other variables will respond.
Check the stated formula, units and limits before using the result in a decision.
Keep the displayed formula, input units and model scope with the result. Corrections or questions can be sent through the request section on this page.
Content updated: October 11, 2026